There are always those approaches that instrument pilots are proud to have attempted and actually made it through. Theoretically, an instrument pilot should be able to perform any instrument approach, but some are a little tougher than others. Some are also more fun than others. Here are a few below that could give an IFR pilot an experience and a story.
Walk into any pilot’s lounge at any airport, ask a few corporate pilots what the best instrument approach plates are, and you will get a pretty even cut down the middle of who prefers which plates. A lot of times, the Jepp guys are Jepp guys because their bosses pay for it. General aviation pilots, on the other hand, largely do not want to pay the high subscription fee, so they choose NACO. Well, I am here to present a breakdown of each, a few pros and cons, and a few opinions. I have used both extensively in my flying career, so I have grown familiar with both publications.
User defined waypoints are extremely handy, but a lot of G1000 pilots do not even know they exist. All instrument pilots are familiar with waypoints. Waypoints are what make up GPS IFR routes. User defined waypoints can be utilized for any type of pilot, whether IFR or VFR.
We have all been that pilot. Whether it is trying to load an approach or just set the altimeter, when we get in a rush, it seems the wrong button is always pushed. That can be frustrating when a flight plan is all programmed in, then it disappears. In my instructing career, I’ve seen my students do it many times. It never results in a safety issue, but it takes a little bit of time to get back to where they wanted to be. Over the next two articles, I will be addressing ten common G1000 mistakes. Here are the first five.
On the long list of what can go wrong in a G1000 cockpit, a Garmin Display Unit (GDU) failure is less of a Maalox moment than other failures. A non-proficient pilot, though, might be lost when the PFD or MFD goes black. Here’s how to handle the situation. (Note: This article will only deal with the traditional G1000 configuration with one PFD and one MFD)